Nissan Pulsar N14 / N15 - Bucket Seat Base Mount

NZKW  Australia Nissan Pulsar N14 / N15 Bucket Seat Base Mount

This seat mount has crossover between N14 N15 and FWD and 4WD 

Please measure FRONT TO BACK on the TUNNEL (centre of car). The number should be approximately 380mm OR 430 mm - This will allow us to supply the right model for your variant.

ADR APPROVED - For seats UPTO 20KGS

Mounting Width- Maximum - 430mm   Minimum - 325mm

Mounting Length- Maximum - 335mm   Minimum - 235mm                                                     

16 mounting point design that fully compatible with major seat manufacturers including ALL NZKW seats

Compatible with

NZKW Bucket seat range - Fixed Back and Recliners   - ADR APPROVED

NZKW Universal Dual-lock Bucket Seats Rails Sliders - ADR APPROVED

NZKW Fixed Back Bucket Seats L Mounts / L Brackets - ADR APPROVED

Requires

12.9 High tensile M8 cap screw bolt pack 

If your mount shows "out of stock" or is on "Special Order" - please contact us for accurate time frames. We may already have this product on its way and may not affect time frames for delivery to you!

PLEASE NOTE- If your model of factory seat has built in seat belt buckle mount, you will require 1x Seat Belt / 7/16 Harness Anchor Double Backing Plate - per side.

ALL NZKW Australia seats and seating related components have been tested and approved to ADR 3/04 and meet the requirements set out in NCOP VSB5

Orders are dispatched within 24 hours, unless stated otherwise at time of ordering.

Online Only: 24 to 48 hours delay, but in some cases up to 5 days, depending on the product and third-party shipping.

Pre-order: Available only for items in transit to our Australian warehouse. Estimated dates depend on third-party shipping.

Special Order: Products we manufacture or need to restock. Average time is 3-5 weeks, but may vary depending on third- party shipping